2002 Nissan Altima "computer" Questions

Where is the on board computer on a 1993 nissan altima? The onbard computer (ECM) is located behind the center console, heres a diagram that shows you the control units and i circled the ecm on board ...

Do I have to reset the. computer if I change the engine Do I need to reset computer if I change engine I would think so. If you go so far as to change the engine the computer would need to be re-set ...

Will a 2008 2.5 engine fit in an 2002 nissan altima It might... but the computer would never be right unless you move the computer and ALL the sensors from the donor car to the Altima... and ALL the ...

the computer does not boot up in my nissan primers sve (52 reg) the computer does not boot up now. it was re-booting whilst i was driving intermittently. now it doesn't bootup at all? help after ...

...out 1994 engine and wiring harness to a 1995 altime Performance I doubt. Problems getting the 95 computer to accept the 94 sensors, possibly. Your options are to switch out the sensors or the ...

...coupe 4 cylinder dead battery after starting it fails emissions test, if I drive enough kms will computer reset? I had a similar problem with my Chevy Malibu! NEW BATTERY = FAIL SMOG TEST in ...

...the crankshaft sensor twice (thinking that was the issue) but no improvement. They now say the computer is not recognizing the sensor and to take it to a dealership or auto electric specialist. ...

2002 nissan altima ecu computer how to reprogram I'm having problem starting my car. I just replace the computer..but because car has anti-theft they say I have to reset the computer.. Most ...

...from your battery and leave it off for at least 20 minutes then hook it back up. That re-boots the computer. If the light comes back on then you have an actual problem not just a spurious code set. ...

CHANGED COMPUTER & NOW IT WILL NOT START There is a part on computers that is programmed to the car they are in that needs to be taken off the old one and place on the new computer I cannot think ...