2000 GMC Sierra "remove ac heater control knobs" Questions

...AC works fine. Air blows fine just cold when set all the way to hot. I drive it 20 to 30 miles and still no hot air. The temp gauge reads just below the middle.. ANy help you can give? I experienced ...

...ac/ heater controls is inside ur instrument panel/ u need to remove the instrument panel to give u access to check whats wrong with ur controls and u need set of tools to do that and be careful when ...

...ac depending on if that has a separte switch else where on control,you would have to remove the actuator and move the door and then some how jam the door so it doesnt move, i think its easier to ...

remove and separate the heater/ac control assembly, replace and re-install as you have taken apart. this is how you would remove the assembly. i hope this solve your question. Stop...it's probably the

ac control knob fell off, how to put it back on? When I worked at the dealership I seen alot of these knobs crack and break and the metal retainer stay on the control shaft,you have to remove retainer

AC control knob Remove the instrument panel trim plate. Remove the HVAC control mounting screws, and pull the unit out untill you can get to the retainers. Remove the old knob, and install the new one

...Remove radio, ac/heater control panel. This usually involves removing a few screws. Find your heater control valve located behind above items. You will see what looks like a plastic box behind the ...

...heater control valve, control knobs and no hot air so mabe its stuk Check the heat/Ac control head. That is most of the time the problem. It controls the door. You can find one in a Junk Yard or ...

ac does not come on even though light Indicates it's on. Has rear defrost and light works..Also has recirculating air button . I'm guessing the whole heating control in dash is bad? Good guess or not?

AC/heater control unit. This is the part which has the AC/heat control buttons and knobs. Easy Diagnosis: The easiest way to verify this is to turn on the radio, press and hold the power on/off button