Question about Opel Cars & Trucks
...torque values for the crankshaft main bearing caps may apply to the 1.4-liter Opel Astra carburetor engine. But as a general rule of thumb, comparable engines often have torque requirements in the ...
Question about Cars & Trucks
...standard value. caution Completely remove all the old FIPG, which might be remaining among the components. 12.After completely removing the liquid gasket adhering on the timing chain case, cylinder ...
Question about Cars & Trucks
standard about everywhere else. So an axle nut torque specification of 162/220 means that the nut should be tightened to 162 ft lbs (foot pounds) or 220 Nm (Newton Meters) which is the same tightness,
...STANDARD BOLT AND NUT TIGHTENING TORQUE in Section TD for tightening torques which are not mentioned in the main text. Furthermore, [3] suggests that one should check the oscillation torque of the ...
...Standard value: 9 mm (0.354 in.) Service limited value: 2 mm (0.0787 in.) INSTALLATION 1.Install the pad clips. 2.Install the pads onto each pad clip. 3.Insert the piston in the cylinder using the ...
...torque to the timing belt and tighten the center bolt to 35 ft. lbs. (48 Nm). When tightening the bolt, be sure that the tensioner pulley shaft does not rotate with the bolt. Remove the tensioner ...
...torque the nut down, and then spot weld the nut to the shaft to prevent it from backing off. This may seem drastic, but it holds. That transmision should be a New Venture 4500,and there is an ...
Question about Lincoln Cars & Trucks
...torque. The ETC system basically replaces the standard cable operated accelerator pedal, idle air control (IAC) motor, 3-wire throttle position sensor (TPS) and mechanical throttle body . Background ...
Question about BMW X3 Series
...standard torque values. These can be found on the chart I have linked below. Be advised that bolt sizes go by the diameter of the shaft [round shaft portion] of the bolt or stud, NOT the hex head ...
Question about Kia Cars & Trucks
...and grade of the bolt and use a table such as you will find by searching on "standard torque values metric system" ...
332 questions posted
Usually answered in minutes!
690 Questions
526 Questions
285 Questions
276 Questions
190 Questions