camshaft sensor twice in the I have replaced the camshaft sensor twice on a 7.3 diesel in the last few months and it has gone bad again not sure what is causing the problem The 7.3 diesel has a recall
...Camshaft position sensor A circuit P0349-Camshaft position sensor A circuit intermittent Check the harness to the sensor for any damage, scrapes, dents...something in your harness may be causing the ...
...camshaft position sensor's electrical connector and remove the camshaft position sensor. Disconnect the electrical connectors for the crankshaft position sensor and knock sensor. 8 Remove the ...
Question about Ford Expedition
...camshaft position sensor on the drivers side. It seemed to drive ok. Headed back to my destination and again going slightly uphill it started shaking with low oil pressure. At this point we towed it ...
camshaft sensor a bank 2 on 2006 ford expedition limited. this truck has 2 sensor on front of head which one is sensor a bank 2 It's going to be the one on the left (drivers) side (picture below). ...
...Fuel Pump Failure Camshaft Position Sensor fail Crankshaft Position Sensor Fail PCM/ECM Failure Timing Chain/belt breakage Alternator fail (low voltage shutdown Each has its own symptomatic
...sensor ring from the crankshaft.Rotate the crankshaft until the timing mark on the RH camshaft sprocket is approximately at the 11 o'clock position and the timing mark on the LH camshaft sprocket is ...
missfire change stii missfired one coil pack plugs wires crankshaft sensr camshaft sensor the upper intake gasket is comman you should have that checked out
...the motor runs rough and check engine light comes on with code p0022 what in the hell is going on Camshaft position'A' timing over-retarded bank 2 not the ...
Camshaft position sensor Where is it located? Hi, My guess would be engine front. Here is a picture of the sensor to help you identify: ...
323 questions posted
Usually answered in minutes!
2,188 Questions
1,825 Questions
1,627 Questions
1,696 Questions
1,161 Questions
