2007 Lexus RX 350 FWD "remove cowl" Questions

Ad

...Remove the cowl vent screen. For additional information, refer to Section 501-02 . Cowl Vent Screen Removal NOTE: To remove the left side cowl vent screen, the right cowl vent screen must be removed ...

Ad

Question about Lexus RX 350

2 Answers

...Remove the cowl panel from the vehicle. Remove the 4 bolts and the windshield wiper motor. Installation Position the wiper pivot arms on the windshield wiper motor and install the bolt. Tighten to 15 ...

Ad

Question about Lexus RX 350

1 Answer

cowl top. Remove hood cowl seal. Carefully remove cowl top vent panel from vehicle. Remove three retaining screws to cowl drain tube that is connected to top cowl. Disconnect wiring harness leading to

Question about Lexus RX 350

1 Answer

...remove RH cowl vent screen from vehicle.Remove two screws and remove cowl top inner panel shield from vehicle.(RH IS THE PASSENGER SIDE THE COWL IS THE PLASTIC PIECE AROUND WHERE THE WIPER BLADES

...Remove the cowl grille seal. NOTE: The two cowl grilles overlap at the center. The LH cowl grille must be removed first. Remove the LH cowl grille. Remove the screw cover. Remove the screws. Remove ...

cowl, remove the screw on the interior side of the cowl, near the evaporator pipe, if equipped. On the engine side of the cowl, remove the 4 screws that hold the heater case to the cowl. On the engine

Question about Lexus RX 350

1 Answer

...six pushpins from the front edge of the cowl top vent panel . Lift up on the cowl top vent panel and disconnect the windshield washer hose (17A605) at the Y-connector. Remove the cowl top vent panel

Question about Lexus RX 350

1 Answer

...cowl. Remove two cowl vent grille panel screws. Remove windshield nozzles and hoses. Remove three cowl vent grille panels. Disconnect windshield wiper motor electrical connector. NOTE: Do not remove ...

...from the wiper motor cowl (4) remove the clips and bolts that hold the cowl to the firewall and remove as an assembly (5) remove the motor and replace it with the new unit (6) reverse removal ...

Question about Lexus RX 350

2 Answers

...Remove the cowl plenum cover/grille panel from the cowl top. (3) Reach through the cowl plenum access hole to remove the two hex screws that secure the front blower motor resistor to the cowl plenum ...

Not finding what you are looking for?
2007 Lexus RX 350 FWD Logo

237 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...