Blower motor only works on 4th setting. 97 Maxima Blower motor only works on highest setting (#4). Is the switch failed, or is the motor the problem.?? its the switch if it was the moror it wouldnt ...
blower motor resistor is defective. I want to buy a new one and replace it. Problem is, where is this blower motor resistor network or card is located. I need help in locating this part in the vehicle
blower motor my blower motor only works on high. i'm guessing a risistor or fuse Not the fuse or it would not work at all,change the resistor.
...blower motor. The blower motor is mounted under the glove box. It is in the corner somewhat covered by the kick panel. The card, at least on my pathfinder, is held in with 2 phillips head screws. The ...
...BLOWER MOTOR FUSE AND RELAY.IF BLOWER MOTOR GOOD STILL BLOWING.CHECK AC COMPRESSOR FUSE AND RELAY.IF COMPRESSOR FUSE AND RELAY GOOD.CHECK AC LOW SIDE PRESSURE SHOULD BE 28 - 30 PSI AND HIGH SIDE ...
...blower motor resistor Honestly its probably not the blower resistor . Its much more likely that you have a corroed connection to the resistor or the motor . Dose it olny work on high fan . Iwould ...
98 frontier has only high fan setiing that works Check /replace the blower motor speed control resistor pack - usually located in the blower fan ducting - in the air flow.
blower motor resistor. This unit is usually located near the blower motor under the passenger side dash. It controls the fan speed for a/c-heater etc. They cost around $25-$80 depending on your model.
blower motor works outside but not when attached to truck Look for the speed resistor close to the motor. It must be open
blower motor. The resistor is located in the passanger side floorboard built into the vent ducting close to the blower motor. There is 4 wire connector (wires are in a row [- - - - ] ) to it and has 2
262 questions posted
Usually answered in minutes!
482 Questions
408 Questions
305 Questions
268 Questions
263 Questions