Question about Hyundai Accent
...High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting Ford specification ESA-M6C25-A. A momentary or slight squirt of brake fluid inside the brake master cylinder ...
...high speed After changing the wheel bearing on the front driver side of my uplander, and put new brake pads, it is now shaking when braking at a speed higher than 60mph. braking at low speed is fine ...
Question about Hyundai Accent
...Replace battery and alternator due to battery light on. Ten miles later I noticed that the volt meter was slowing creeping up and down. When it reaches around 17 volts numerous instrument lights come ...
Question about Cadillac Cars & Trucks
...replace the brake switch.still not working any advice Stop Lamps The brake pedal position sensor is a resistive device used to sense the action of the driver's application of the brake pedal. The ...
...list. ? If less than 10 volts, test the ground circuit of the EBCM for high resistance. If the circuit test normal, test or replace the EBCM. Go to Battery Inspection/Test and Charging System Test
Question about Hyundai Accent
...replace-abs-pump-assembly-on.html ----------- How to remove ABS Accumulator on Acura Integra? http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-accumulator-on-acura.html --------- How to ...
...high shift effort. Verify that all the lines and fittings are dry and secure. Clean the dirt and grease from the reservoir cap in order to ensure that no foreign substances enter the system. Remove ...
...replace the bulb, and install the bulb & socket into the lamp assembly, and re-install the lamp from inside the car, slowly and carefully slding it back into place. (hint, the more of the flat tip ...
Question about Saturn Cars & Trucks
...Brake Switch Circuit 1 High Voltage It's hard to fix something when you don't have a clue how it works . The CC is also a controlled function of the BCM . The BCM monitors the signal circuit of the ...
replace the motor) 2) Recall #: 13036 "Brake Lamp Malfunction". The dealer will add a spacer to the wiring harness and apply die-electric grease to the connections to the body control module and brake
264 questions posted
Usually answered in minutes!
1,131 Questions
1,082 Questions
1,047 Questions
517 Questions
500 Questions