key will lock and unlock and the egnition will turn but car wont start. playerfoul3, i had the same thing happen to me. you have a smart key and there is a chip inside the key that must be read by the
...close to the size of the egnition an a hammer remove key fist an drive it home an then try key again if it doesnt work replace egnition if it does work dont remove key till u ready to replace ...
egnition lcoked i cannot turn the key, egnition is locked As you turn your key to start, at the same time move your steering wheel side to side until it unlocks
key not turning egnition try yanking on the steering wheel. the wheel locking mechanism is tied in to the key ignition (locks the wheel when ignition is off)... the wheel should enter fully into the ...
...SUPPOSAE TO EXTRACT A KEY FROM THE EGNITION IF IT IS BROKEN. remove the whole lock and tap it out if you are lucky ,normally i just cut them off and renew the whole lot if the key is broke in the ...
...egnition on but not start open driver door. lock door lock by hand.aim remote at sensor and hold down lock button on remote till you hear it lock. within 15sec after you hear it lock turn key off and ...
...key not programmed to lock doors 1st: there is a switch in the car that is lock/unlock the car, switch egnition on and push the switch, when the car open and close then the pomp is ok so u have to ...
I was at the drive in and my car battery had died. I tried to jump it and the key would not switch out of the "lock" position.How do i get the key to turn the car over after i jump start the car? this
I turn the key off but engine stays runnung. power locks work only when engine is running. Bad egnition switch
i have a 96 ford ranger and i wont stop dinging.it has something to do with they egnition lock and key realese.what can i do? Disconnect the black and pink wire under the steering column.
458 questions posted
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions