Frigidaire Affinity 5.8 Cu. Ft. Gas Dryer "board control dryer" Questions

Ad

...Control board problem. Unplug the dryer for 5 minutes to reset the control board. Plug the dryer in and start a cycle. If the code appears, replace the electronic control board. ...

Ad

...control board. Unplug the dryer or turn off the breaker to the dryer. Double check to make sure dryer has no power. Remove the screws holding the top on at the back of the dryer. Standing in front of ...

Ad

...control board, when lights burn out they surge and this can destroy a control board, I looked up your dryer # to see what control board it uses and it comes up as a refrigerator, you may want to ...

...control board If so what were the symptoms before you changed it ? Does the dryer heat up ?How much of the dryer did you disassemble? Did you check the vent for lint buildup? Does the dryer display ...

Question about Kenmore Dryers

1 Answer

control board and the user interface control board that could cause there error messages and symptoms. The first image below shows how to access these components. I recommend that you unplug the dryer

...control board is likely to have failed. Unplug the dryer for 5 minutes and the plug the dryer back in. If the code reappears, replace the main electronic control board. This is where I would start. ...

control board - however there is a red light that will flash, replaced thermol fuse, main control board, control board behind the start button- (2) - replaced - hi limit behind the thermol fuse. After

Question about Kenmore Dryers

1 Answer

control board. The thermistor attaches to the control board on the P2 connector (red/white and black wires on pins 5 and 6). The image below shows the procedure for accessing the control board in this

Question about Whirlpool Dryers

1 Answer

...control board and the user interface control board assemblies. Unplug the dryer. Check the wire harness connections between the main electronic control board and the user interface control board ...

...control board failure . If the error cleared after unplugging it for a while, then the control board could have received a power surge or glitch through the electrical lines. Completely disconnecting ...

Not finding what you are looking for?
Frigidaire Affinity 5.8 Cu. Ft. Gas Dryer Logo

133 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Paul Bade

Level 3 Expert

1818 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...