KitchenAid Artisan Series Tilt-Head Stand Mixer "bowl mixer keeps coming" Questions

...off the base. Sounds like "magilla the gorilla" put it on the base. Just keep at it. You might try putting some ICE in the bowl to "shrink" the bowl. the stand mixer cant be used for more than four ...

...mixer attachements grind on bowl. pin keeps coming out that holds the top assembly to the base. mixer attachments are grinding on the bowl. looks like whole top assembly is titled downward slightly. ...

...Mixer Bowl Lock Plate 4163032 This part is really easy to replace, it is held into place with three screws, remove those screws (make sure to hang onto those you will need them to re-install the new ...

...the dough hook. I think there is to much space between the bottom of the dough hook and the mixing bowl. Sorry but this is not possible on this model (can not be adjusted) And just to let you know

...bowl strikes and adjusting the head height only hides the problem. The head of the mixer is secured to the base by a large steel pin. Any play between the head and base comes from this hinge and its ...

...mixer bounces up when kneading dough This happens when locked. The locking mechanism gives way more with each bounce - I've had this happen before and repaired by the factory. This sounds like an ...

...bowl to make contact with the mixer blades. It is very hard to turn, hardly at all. I wondered if I should spray some wd-40 on it or just oil put oil on the springs, which seems to be the problem. If ...

...bowl lift mixer bowl support Bowl support rocks a little from side to side when it runs, even when the bowl is in the locked position. Is there a screw I can tighten to stop it from rocking? Keep in ...

...keeps cutting out during blending and mixing need clarification. what does cut out mean? The motor stops altogether? The beaters stop spinning but you still get motor sounds? It comes on and goes ...

bowl When I use my mixer the paddle, of late, is rubbing the bottom of the bowl, which is causing the white enamel on the paddle to wear off. This enamel apparently is going into what I am mixing. Isn