DRYER WILL NOT HEAT UP. "DRY" LIGHT FLASHES AND "COOLING" LIGHT STAYS ON CONTINUOUSLY. You dry by sensor??? Clean your sensor. The machine thinks the clothes are dry because the sensor is covered with
dryer off start it up and look for the glow. when it glows hot enough (or on a newer model it might be a spark) the gas should ignite. When the flame sensor sees that the gas is ignited it shuts
sensor for the water inside the dryer. you say that even if you already put water in it, the light is still on correct? which means that the dryer does not detect or sense that water is already there.
...dryer shut off. Sensor light was lit on wet. The dryer will not start under any settings. Sensor lights will flash on sometime, if I turn the timer to auto sensor timer but only for a split second. ...
...and this may have a film on it from the dryer sheets. The easiest and safest way to clean is take it apart(the dryer) gently/lightly wipe the sensor off. Be careful not to damage it, Good Luck ...
...Dryer Moisture Sensor Bar part WP3387223 How To Replace (See the KENMORE note below)... You MAY want to try cleaning the Sensor with a Q-Tip and alcohol! Not too much though... just a dab. more from ...
Question about LG Dryers
sensor dryer is set at 44 minutes but timer drops and does not dry for 44 minutes The sensor is sensing that the load is done. Even if it is not completely dried. The two sensor bars inside your dryer
...the flame will stay in. During dryer weather, the dryer seems to work fine. Flame sensor next to the burner is eather bad or there is a bad connection at the flame sensor (that's why the kick
dryer sensor light blinking Sensor light stays on press the End of Cycle button (hold down for 3 seconds, it should reset).
reverse light switch location 2000 honda civ DX all lights working but reverse white tail lights, all fuses are ok switch is on transmission. or near shifter.
44 questions posted
Usually answered in minutes!
1,123 Questions
940 Questions
790 Questions
215 Questions