Question about Maytag Washing Machines
...water inlet valve how ever the problem is still there. I did reverse the hot & cold hoses..............it did the same thing with the cold water Hi Daniel. I've heard of this problem before. In that ...
...water inlet valve has failed. Replace it. Pressure Switch If the washer is overflowing the pressure switch might be defective. The pressure switch is attached to a small tube which is attached to the ...
...water into washer. I have cleaned out the inlet of Lime. If you have checked the valve filter and it is clean then a couple of possibilities, the valve itself could be not opening properly due to a ...
MVWB850YWO OVER FILLS HITS OL CODE You may have a low inlet water pressure caused by the water inlet valve which can stick and cause low pressure-also check pressure sensor hose for blockage
Question about Washing Machines
on the inlet then check your tap and water line. Otherwise check the INLET filter, check the command to the inlet valve and if the inlet is timed out then there is fault on the program controller unit
...through. 1. Do as you already did and clean the inlet filters. Any kinked hoses? 2. Adjust the water pressure in the house. Is it too high or too low? 3. Replace the valves in the unit. 4. Main
...water inlet valve keeps running water , again when restarting the machine ithe solenoid of the inlet valve is allowing thin stream of water instead . Is the problem from te inlet valve or the fuzzy ...
water inlet malfunction). I've rigged the door switch to let the machine run with door open... On any program the machine drains then let's water in but after a minute or two the error code reappears.
Question about AEG Washing Machines
...water inlet, valve does not open/ interruption or flow rate too low. So I suggest to you following: check water inlet, clean sieve, check inlet valve, check pressure sensor and finally check wiring. ...
...inlet water valve. Remove the inlet screens and wash them under slowly running water by rubbing your fingers over them. Reinstall the inlet screens and re-connect the water hoses to the machine. ...
231 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions