RCA INPUTS AND MEASURE THE DC VOLTAGE AGAIN. IF IT DISAPPEARS, THEN YOU HAVE A PROBLEM WITH THE STAGE BEFORE THE AMPLIFIER WHICH IS EITHER THE RADIO OR OTHER DEVICE SUCH AS ANOTHER CROSSOVER, EQ, ETC.
...RCA CABLE OR RADIO ITSELF. YOU CAN VERIFY YOUR FINDINGS BY STARTING WITH THE SPEAKERS FIRST. SWAP THE SPEAKERS AROUND AND IF THE PROBLEM STAYS ON THE SAME SPEAKER, THEN THE SPEAKER IS AT FAULT AND IS ...
...radio, there are no preamp outputs, so you will need to use the speaker outputs. The best solution would be to wire a LOC (line output converter) to the rear channels and run RCA cables to the amp. ...
...RCA INPUTS AND DISCONNECT THE SPEAKERS, THEN POWER THE AMPLIFIER UP WITH THIS NO INPUT, NO SPEAKER LOAD CONDITION. IF IT STILL GOES INTO PROTECTION AND YOU HAVE VERIFIED THAT THE POSITIVE AND ...
Question about Infinity Car Audio & Video
...radio. Note: The auto turn-on feature does not operate when the preamp level inputs are used, unless the remote turn-on lead is connected.Low-Pass Crossover: The low-pass crossover frequency can be ...
Question about MTX Car Audio & Video
RCA JACKS FROM AMP TO REAR SPEAKERS FOR SIGNAL FROM RADIO. VEHICLE HAS FACTORY KICKER 'LIVIN LOUD SYSTEM IN IT. EMAIL [email protected]. THANKS!! If the amp produces no boom with no signal
10 questions posted
Usually answered in minutes!
55 Questions
42 Questions
24 Questions
26 Questions