Frigidaire GLTF2940ES Front Load Washer "door ptc circuit" Questions

...door PTC circuit is open during spin. Power off the machine and then back on again after 30 minutes to clear the error display. If the error comes back again then you will need to look at the PTC ...

...door PTC circuit is open in spin; Manual suggest to remove the door lock assembly and measure the resistance of the PTC. Suggested Correction is ''Shorted or open. Defective door lock assembly. Reads ...

door PTC circuit is open in spin. E48 Board thinks the door PTC circuit is closed. E52 Bad signal from tacho generator. E55 Motor overheating. E56 High motor current. E57 High current on inverter. E58

door PTC circuit is open in spin. E48 Board thinks the door PTC circuit is closed. E52 Bad signal from tacho generator. E55 Motor overheating. E56 High motor current. E57 High current on inverter. E58

door PTC circuit is open in spin. E48 Board thinks the door PTC circuit is closed. E52 Bad signal from tacho generator. E55 Motor overheating. E56 High motor current. E57 High current on inverter. E58

...PTC (contacts 3-5 on door interlock device, no.3 on electrical diagram) is powered by the triac (DOOR TY) on the PCB: after 2 - 4 seconds, this closes the switch (5-4) which powers the electrical ...

...door PTC (positive temperature coefficient) circuit is closed. This particular part is the wax motor on the door lock. One of the best ways to determine if this is a false error code is to reset the ...

...the unit is in spin cycle - Remove the door lock assembly and measure the resistance of the PTC. Shorted or open, defective door lock assembly. Reads around 1500 ohms, defective Main Control

...to complete the following:Remove the door lock assembly and measure the resistance of the PTC. Shorted or open, defective door lock assembly. Reads around 1500 ohms, defective Main Control