Frigidaire Gallery GLEFM397DS Electric Kitchen Range "turned stove power went" Questions

...stove after turning on oven and hearing a loud ''POP'' Turned on over, approx. 20 seconds later, a loud ''POP'' sound, like a gun shot. Stove went dead, no power except for oven light which works. ...

stove quit heating. Suddenly the clock went out. We turned the power off and I reset the circuit breaker to the range. The clock stayed off, but when we turned one of the eyes back on, the oven buzzed

stove top was turned on. Do you know what's wrong? This sounds like your power relay board went out on this unit. Jessie, we have parts for Kenmore appliances, so contact us with your model number and

...stove out and unplug it check power at the plug you need 240volts at the plug. If i dont have a plug and wired straight in disconnect the wires and check the wires. You have a incoming power problem. ...

...stove works, oven turns on briefly then shuts down Power recently went out at our home. We have a Jenn Air 8114P electric range. The stove top works fine, but the oven only comes on for a moment and ...

stove breaker back off then turned the power for the house back on. Obviously a real problem with the stove. Any ideas? element has blown, pop is it breaking, that heating element will need replacing,

power to the stove on and off and re-attempted to turn the stove on once again; this time i got a code "f5" and was not successful turning any of the burners on. The burners on the right displayed "f5

...turned off and on the reset the stove and that seemed to work. However, this morning there was no power at all to the stove. I tested the outlet and both legs have power. Does anyone know what could ...

...stove and when the power went on and off the oven will not work. The display shows F1 and will not allow me to reset the clock or use any buttons assoiciated with oven. The stove top works just fine. ...

Power must be reaching the stove for the lights to work so it would seem something has gone wrong inside the stove. Only exposing the internal connections and testing the circuits will trace the fault