Krups KM7000 "thermal fuse coffee maker model" Questions

...thermal fuse should be located near the coil. Usually just below the plate, but that all depends on the model. I hope this helps! :) They are inline with the thermal cutoff switch, which is attached ...

...thermal fuse model GRX-B If the fuse inline in the wire(s) to the heating element, simply cut off the old fuse, strip back the wires a little and insert a new thermal fuse using either but crimp ...

thermal fuse or heater does heater work under coffee pot? :) check continuity across the thermal fuse and through the heating element. My thermal fuse was fine the heating element is bad. Can't find a

...After cleaning I went to make a pot of coffee. Nothing happened. It is only about 2-3 mos.old Probably the failure of another Chinese thermal fuse. Your coffee maker should still be

...thermal fuse at Radio Shack. The closest one to the specs of the Microtemp is a Radio Shack part number 270-1321 rated at 228 Degrees Centigrade. Before removing the old one notice which way the hat ...

...model b-40.power light comes on and nothing happens. Probably failure of a poorly made Chinese thermal fuse. Other owners of this brand have gotten replacement for other models; contact them

Is there a recall on bunn coffee maker model number btxb Brews but doesn't heat * Element or thermal fuse blown. Check for warranty and replace. Call your vendor. Aloha, ukeboy57

...thermal fuse has failed. Remove enough screws to get to the tank on top of the appliance (usually aluminum). You'll see a small device with wires on each end attached to the tank, perhaps by a ...

coffee makers are related to thermal fuses which have opened and interrupted the current flow to the heating element. Often, they failed for no particular reason but replacing the fuses would probably

...old. The thermostat that controls plate temperature has stuck closed. Stop running the machine until this problem is repaired. A thermal safety fuse should have blown (stopping any further