Yamaha HTR-6030 Receiver "select speakers front" Questions

you switch various modes, it makes auto adjustments based on what you had set in the past. Hope this helps On the front panel there is a sp a/b/off. I had to select b for my front two speakers to work

...front and rear,, switch the speakers to rear to make sure the speakers themselves are working correctly, by allowing the headphones to produce sound its letting you know the outputs for the receiver ...

speakers are very quiet. My book says I should be able to adjust the volume of each speaker. According to the book I press "test tone" on the remote then MENU to adjust the sound level of each speaker

...select button on the front lets you select front A or front B (or neither) - is there a way to select front A + front B, and output to both sets simultaneously? Thanks... no on

...and rear speaker level to 10.0 ,in the selections put your front and rear speaker size to large and u enjoy your product,i got four 140w pure acoustics speakers onto the receiver and it plays ...

...speakers to SML). ? Select BOTH if you connect a subwoofer and you want to output low-frequency signals from front channels to both the front speakers and subwoofer. LFE and low- frequency signals ...

...speakers with the diagnostics software of the sound card and everyone of them works fine. Just doesn't work when I play mp3 or movie. configure ur PC (both OS audio and third party sound driver) for ...

...speakers. Then of course you just select either A or B depending on where you want the sound to come out. If you select A and B then it will come out at both locations. If you don't have A/B speaker ...

...front speakers and "Both" (Front speakers and subwoofer)for LFE Bass response selected. there's no test tone under normal use for the sub. It only shoud test the three front and two rear. ther' are ...

...setup. select ur speakers large or Small or large according to ur speakers. then test again. if u connected an analog audio input then press surr (surround mode button) to select the mod you want) ...