Power Acoustik LT-980/2 Car Audio Amplifier "protect amp" Questions

...amp will trun on but it wont put out any sound when hooked up. the protect light comes on and stays on. it's blown....probably, check your connections and make sure your presenting it an ohm load it ...

...amp is either going into protect ... How do I fix my amp it keeps going into protection mode ... ? 2:00 https://www.youtube.com/watch?v=DQ1bdsm6s2c Apr 24, 2013 - Uploaded by Nathan West My MTX 600xd ...

...amp is in protect mode how can I my nitro bmw-486 amp it just turn in protect mode is there a way that I can fixed protect mode is activated either because of a short in a speaker wire or because of ...

...amp is still in protect then your amp is bad, if the protect light goes off, then your subs are bad, or possibly wired at to low of an impedance, but I don't think that will trigger the protect on an ...

Amp in power protect Hello, I have an amp installed but can not get it to come out of power protect mode. All wiring and fuses have been checked. I have disconnected all RCA and speaker wires and put ...

...Troubleshooting - Amp in Protect Mode You have a wiring problem somewhere either power or possibly your speaker wiring The amp has either been pushed past it's limits or has a component thats

protect mode The amp will not come out of protection mode. All wires unhooked. even tried alternate power source. A new amp is installed to same setup as this and has had no problems. Help Hi. The amp

...amp the red protect light stays on and it wont let my amp work and when you take out the fuses the red light goes off If the protection LED lights only after the remote voltage is applied (head unit ...

...protect light amp is bad and if you have no protect light continue to hook up each speaker one by one while amp is on till you get a protection light and that speaker would be the source of your ...

...amp will go into protect. I have also seen many, many MTX amps that go bad, and just stay in protect. the easiest way to check, is to unhook the speaker wire from the amp, then power it up, if it ...