Power Acoustik LT-980/2 Car Audio Amplifier "bridge 4 ohms 2" Questions

4 ohm stereo or bridge mono output 4 ohm stable in bridge mode this mean can't go lower then 4 ohm or can series parallel 2 subs 1200watt 4 ohm singel coil to amp You can't bridge that amp onto a load

4 ohms...............40W, 0.08% THD Per channel into 2 ohms ..............50W, 0.3% THD Bridged into 4 ohms.....................100W, 0.3% THD RMS Continuous Power (at 14.4V) Per channel into 4 ohms..

BRIDGE IS BURN OR MY 2 CHANNEL? PLEASE HELP From the specs this amp can only handle 4ohms when bridged but can handle 2ohms when it's not bridged Specifications Continuous Power (20Hz-20kHz, 0.04% THD

...4 ohms and 140 watts x 2 into 2 ohms. ... Output Power at 14.4V (20Hz ∼ 20kHz): .High Current Mode: 2 x 50W @ 4 ohms (0.04% THD) 2 x 70W @ 2 ohms (0.1% THD) 1 x 140W @ 4 ohms bridged (0.1% ...

...back down to 4 ohms when you bridge it. 2 4 ohm speakers wired in parallel is 2 ohms then dropped down to 1 ohm when bridged (most amplifiers will not handle loads below 2 ohms) hope this info ...

4 ohms BRIDGE <=1% THD+N 75 dBA Signal-to-Noise Ratio Peak Music Power: 250W x 2 (4 ohm) / 760W x 1 (Bridge) 2 Channels Continuous Power @ 4 Ohm: 125W x 2 Continuous Power @ 2 Ohm: 190W x 2 Continuous

...4 ohms bridged mono ans 2 ohms stereo. If your running it in stereo you need to raise the ohms to 2 ohms a channel and if your running it bridged into 1 channel you need to be running it at 4 ohms. ...

...say the following: 4 Channel 100W x 4 (4 Ohm) 4 Channel 150W x 4 (2 Ohm) 2ch Bridge 300W x 2 (4 Ohm) But.... it tends to go into protection quite fast so i wouldn't go too low with speaker

4 ohm speakers that are wired in parallel and then you bridge them, you have a 2 ohm load. They only safe way to use two 4 ohm speakers is to run one speaker to each channel and then you have a stereo

...4 ohms 300 watts x 2 chan. @ 2 ohms 450 watts x 2 chan. @ 1 ohm Bridged, 300 watts x 1 chan. @ 4 ohms Bridged, 600 watts x 1 chan. @ 2 ohms ...