...back down to 4 ohms when you bridge it. 2 4 ohm speakers wired in parallel is 2 ohms then dropped down to 1 ohm when bridged (most amplifiers will not handle loads below 2 ohms) hope this info ...
...bridge them, you have a 2 ohm load. They only safe way to use two 4 ohm speakers is to run one speaker to each channel and then you have a stereo 4 ohm load. When you use a 2 ohm load you get twice ...
Question about Rockford Fosgate Car Audio & Video
...2 ohms @ bridge mode. Hey Rockford amps have 2 speaker connections A and B there both for a(single) 4 ohm speaker/sub. If you cheek your manual or download them like i do you will notice its for 2 ...
...bridge by using 1 channel? A 2 ohm stable amp should be able to be bridged to 1 ohm (consult owner's manual for bridgability), but a 4 ohm speaker is a 4 ohm speaker and would need to be parallelled ...
...2 ohm load. However, if you are bridging the ouputs then a single 4 ohm speaker bridged between the two outputs will put a 2 ohm load on each channel. Be very careful if you are bridging the outputs ...
...2~8 Ohm (Stereo), 4~8 Ohm (Bridged) Continuous Power (4 ohm) 125W x 2 Continuous Power (2 ohm) 190W x 2 Continuous Power Bridged (4 ohm) 380W x 1 Frequency Response 10Hz ~ 50kHz Total Harmonic ...
...2. The manual says bridged output is for subs. I have Pioneer 4-way(4 ohms)6x9's rated max 300 Watts ea. Can I bridge them instead with the full range selected in the built in crossover? If so, what ...
...Bridge) 2 Channels Continuous Power @ 4 Ohm: 125W x 2 Continuous Power @ 2 Ohm: 190W x 2 Continuous Power Bridged @ 4 Ohm: 380W x 1 Frequency Response: 10Hz-50kHz THD (1kHz, 4 Ohm): <0.015% Signal to ...
Question about Lanzar Car Audio & Video
2 ohm speakers wont work on a lanzar max pro 4000 watt I had an alpine type x 10 bumpin with this lanzar when it fried. I then tried a 2000 watt at a 550 rms 2 ohm dual voice coil mtx speaker. But the
...and use 1 amp per speaker bridged mono @ 2 ohms. Connecting the outputs of power amps together is not advisable. since the sub is dual 1 ohm and is wired to 2 ohm get a maxilink and bridge at two ...
68 questions posted
Usually answered in minutes!
25 Questions
19 Questions
28 Questions
18 Questions