Question about Infinity Car Audio & Video
...number it is literally a guess as to how many amps per channel or any other question regarding it. if you have a multimeter that measures watts that would be the only way to tell otherwise. good ...
Question about Concept Car Audio & Video
...per side (45 watts for left, 45 watts for right), that's unless they are one of those exotic higher end brands (eg: Boston Z6s which are 3 ohms). Rarely, you will find speakers that are rated at 2 ...
Question about Car Audio & Video
watts than the speakers?k Speakers are rated either at RMS (root mean square) average power or Peak Power. An RMS of about 125 watt is equivalent to 250 watt peak. To match the radio and speakers they
...amp what is the rms output Dynamic Power Rating (measured at 14.4V): Bridged Into A 4-Ohm Load: 450 watts x 1 Per Channel Into A 2-Ohm Load: 225 watts x 2 Per Channel Into A 4-Ohm Load: 115 watts x ...
...per Channel @ 1% THD 75 watts x 4 into 2 ohms @ 14.4 Vdc Nominal Continuous Power per Channel @ 1 % THD 35 Watts x 4 into 4 ohms @ 14.4 Vdc IASCA/USAC Power Rating 12 Watts x 4 into 4 ohms @ 12.5 Vdc ...
Question about Cyclone Car Audio & Video
...the JL Audio M2150. To run both front and rear channels, you need a 4-channel amp with 50 watts RMS per channel. The Kicker MX350.4 marine certified amp would be a good choice. Hope this
Question about JBL Car Audio & Video
...watts PER PAIR! 300 watts EACH! TWO 12" HFi Series Subwoofers ALso i hook them up with sub box that is no port. any idea fpr that If the amp is 1200 watts at 2 ohm stable you will want to set up the ...
it cannot produce more than ~20 watts of real power per channel. There's no way that it can drive the high end speakers to a level that will be needed to compete with the subs on a 1000 watt amplifier
...amp (800 watts peak 100 watts per channel rms) for $100 shipped with full factory warranty. you find an amp you like and i will get you a price. I am a factory wholesale distributor for most
...watts per each coil). If your L7 is the 2ohm version, you should wire the voice coils in series, the positive marked coil to the negative unmarked coil. Then connect the remaining positive and ...
68 questions posted
Usually answered in minutes!
25 Questions
19 Questions
28 Questions
18 Questions