...Check FU202 on the dc power supply board. Good No Good Replace FU202 Replace the dc power supply board. Check the voltage at CN105-1 and 6 on the main board. 24 volts 0 volts Replace the main
...replace a DC controller board Hi, When replacing DC/main PWB or engine board, be sure to remove the EEPROM from DC, main PWB or engine board that has been removed and then re-attach it to the new ...
Question about Ricoh Office Equipment & Supplies
...Replace the main control board. [Signal Check] ? Feedback signal: CN209-9, TP264, or CN211-A4 on I/O control board / CN302-A6 or TP106 on main control board. ? PWM: CN209-10 or TP272 on the I/O ...
Question about Canon Office Equipment & Supplies
...replacing the main board it sorted the problem out!Could have been a spike in power and also a dry joint on the board,It will be cheaper replacing the printer than replacing the main
...find your code and the replace the bad part. The battery is on the main board. The EPROM is on the main board. If you find your code, replace the part and error still remains -- replace main
Question about Gestetner Office Equipment & Supplies
replace the continuity the expo lamp,expo thermofuse.The E codes are displayed in the copy counter.To display both digits of the E codes press the enter key. E 11 - Exposure lamp error.Possible cause:
Question about Kyocera Office Equipment & Supplies
...YC3 on engine board. chk terminal continuity, if not replace the terminal. Very rarely main board or engine board may go bad. If you are facing any difficulty, download the manual go through
...find your code and the replace the bad part. The battery is on the main board. The EPROM is on the main board. If you find your code, replace the part and error still remains -- replace main
Question about Compatible Office Equipment & Supplies
...main switch off and on. 2. Check or replace the cable connecting front (for C&M) or rear (for K&Y) synchronizing detector board and the LD unit. 3. Check or reinstall the front (for C&M) ...
Question about Cannon Office Equipment & Supplies
...Main Controller Board (J5) and Contact Sensor. (2) Replace the Flat Cable between Main Controller Board (J5) and Contact Sensor. (3) Replace the Contact Sensor. (4) Replace the Main Controller
10 questions posted
Usually answered in minutes!