Whirlpool LGB6300 Gas Dryer "initially heats gets cold" Questions

...a dryer heats initially and then stops heating a coils has gone bad. Save yourself the repair call and replace the gas coils. They're a $30 part and it takes all of five minutes. Works like a

Initial heat then goes cold whirlpool LG5801xsh3 gas dryer starts to get hot (most of the time) then goes cold Very common change the gas valve coils and you are good to go easy repair i can ship them

gets hot when initially started but shortly after gets cold. I cleaned the lint screen, removed the exhaust hose an blew the debris from it, cleaned the lint screen housing and the inside of the dryer

heats up initially then goes cold and stays cold. The energy saving drying feature will not shut off because the clothes never get dry. Sounds like you need to replace the coils on the gas valve. Just

Replaced thermal fuse, and gas valve coils, now no heat at all! Similar to other postings, dryer would start, gas would ignite, and heat would last about 10-15 minutes then go cold. I replaced the ...

...heats up initially, then continues to only blow cool air. Vents are clean. Hi, very common problem. The problem is with the gas coils. When they get weak, they only come on for about 10 minutes and ...

...Heats up initially for long enough to get hot inside then cools down, heats up again maybe once then will not again. Pilot comes on but main burner does not light on repeated cycles. I have replaced ...

I have a Amana Gas Dryer. Model No: LGA30AW. The dryer runs. When I turn it on, it will heat up and then it will eventually get cold. Sometimes I hear a rattling noise. sounds as if the coils atop the

...initially for a minute only to turn cold again. What's the problem? check the high limit/cycling switch thermostat located on the heat housing ,you will need to remove the front panel to access ...

...COLD air blows out well, the venting is not clogged, but the air in the drum doesn't get heated, AND the timer stays right where I initially set it, even if it is tumbling hours later. What would ...