Whirlpool LGB6300 Gas Dryer "heating replaced igniter" Questions

...heating at any setting. Is there more trouble shooting I can do to solve the problem? Thanks. Check the following to address this issue. 1. Gas valve coils Igniter glows, then shuts off without ...

...heating. We replaced the ignitor. Still the same problem. All the wiring checks out ok. If it does not heat , and you already checked the burner and the ignitor, then it is probably the thermal fuse ...

...heating issue 1. Gas valve coils Igniter glows, then shuts off without igniting gas - the problem is probably with defective coils (black, located on top of the gas valve). It is recommended to ...

will not ignite, preventing the dryer from heating. To determine if the igniter has burned out, use a multimeter to test the igniter for continuity. If the igniter does not have continuity, replace it

...heating or drying. The dryer was working just fine last night, but this morning it won't heat. It still turns, but there is no flow of air. I checked the outside lint catcher and cleared it out, but ...

...igniter) if found defective. electric dryer 1 Heating element A burned out heating element will show no continuity when measured with a meter. Replace the element if found defective. 2 Thermal fuse ...

igniter. Does it glow bright orange, then shut off without igniting the gas? (When the gas ignites there's a large blue flame.) If so, there may be defective coils on the gas valve. Mounted on the top

igniter. Does it glow bright orange, then shut off without igniting the gas? (When the gas ignites there's a large blue flame.) If so, there may be defective coils on the gas valve. Mounted on the top

heating coinl or whatever it is then after 10 min or so I go down and still spinning but no more heat Hi, the most common issue will be a set of defective coils but, i suggest that you run through all

...heating. The fuse is usually located on the vent duct, inside the dryer. A blown fuse will show no continuity when measured with a meter. Before replacing the fuse, make sure the blower wheel is not ...