Whirlpool LGB6300 Gas Dryer "energize" Questions

Dryer won't start. Tried a new start button, then tried a new thermal fuse. Any suggestions? Check the starter switch on the motor, Push button switch energizes the starter windings on the motor, but ...

...element or a thermostat check voltage going to the heater,if no voltage check the contactor if energize,if not energize,close the power and check the thermostat with multimeter and test the ...

...it run and tape it in the run position, your missing the voltage from the control panel timer to energize the relay to keep it energized after you push it to make it start,you need to trace this ...

...only glows on permanent press cycle and not timed cycles The glow bar on my dryer only seems to energized through the permanent press cycle and not on the regular timed cycles. Lately it only ...

ge dryer the dryer is working but it will not turn off when the timer runs out it will when you open the door what could it be The door is interlocked to stop the drum from turning and.or causing an ...

...power from the control thermostat and fuse mounted on the blower. All of the components are energized at once but the gas will not be ignited untill the glowbar has reaced 1800f and tripped ...

...the gas valve. If you see it glow, put your volt meter on the gas valve terminals to see if it gets energized. If it doesn't energize before it locks out, then let the HSI cool down to room temp and ...

...I release my finger from the start button That's the start relay causing that. It is supposed to energize and stay pulled in to

...need to replace the entire motor/switch assembly. Also the switch controls one or power relays to energize the drum motor and heater. Check to see that the relays internal contacts are not burned ...

...but when I push the start button it will not kick on The start button goes directly to the motor to energize the start winding until the centrifugal switch in the motor energizes the run winding. If ...