Whirlpool LER4634J Electric Dryer "replace drum" Questions

...is correctly located and clipped in. Replace the lens on the sensor module. Replace the sensor module. Remove Top Deck and clean the sensing bumps on the outside of the drum end. Replace the

...is the kind with rotating drums, might be a bearing. You should disassemble it and check if can be replaced Dryer Repair Replacing the Drum Bearing GE Part WE3M26 Dryer Repair Replacing the Rear

replace the drum and belt assembly, Check you drum rollers for flat spots, If they have flat spots on them replace them. I would also recommend that you lubricate your drum rollers with a good quality

...drum to replace felt I need to replace the felt of the dryer and am having a bit of trouble lifting the top of the dryer to access the drum. Any advice on how to get in there??? GE Model # ...

dlg5988s gas dryer drum wont turn Replaced old cracked drum with brand new drum, also replaced front rollers that were worn and chewed up from old drum. New drum will not turn. We have checked ...

...flat spots, if they have flat spots on them this will cause a noise like a thumping type noise. You will need to replace the drum rollers if they have flat spots on them. Good luck, I hope this ...

drum to stop turning. If necessary, replace the belt. Check the motor: Even though you have already replaced the motor, it is still possible that it is faulty. Check the motor for any signs of wear or

...replace. Drum rollers, Drum slides and idler pulley. You can check these parts before you replace them. If the drum rollers don't spin real easy, replace. If the idler pulley does not turn easy, ...

...is slipping. Other possibilities are: A drum support wheel bearing could need lubrication or be replaced. Also some drum support wheels have a rubber coating that wears off causing misalignment ...

...replace the blower wheel. Drum Bearing The drum bearing supports the rear of the dryer drum. If the dryer makes noise this bearing might be worn out. Replace the bearing if it is worn out. Do not ...