...happens Is the power cord plugged into a grounded 3 prong outlet? Plug power cord into a grounded 3 prong outlet. Are you using an extension cord? Do not use an extension cord. Has a household fuse ...
...remove any debris. The manual says to use half of the regular amount of high efficiency detergent and run on the Normal/Casual cycle. I followed these directions as written. The bottom of the drum ...
happens. Can you help? Hi, If you remove three screws along the bottom front the bottom panel comes off. On the inside, on the right wall, is a plastic bag with a paper labeled "FOR SERVICE TECHNICIAN
...shipping bolts, spacers and cables are removed. 2. Unplug washer or disconnect power. 3. Check wire harness connections between the drive motor and the Motor Control Unit (MCU), and between the MCU ...
...happens when the control unit is unable to properly detect motor speed. If you are planning on doing this yourself then in order to troubleshoot this you will need to remove the back panel to gain ...
...out fine without clothes in it, but is walking moving around floor when clothes are in it. How can we stop this from happening? Did you read the manual and remove the shipping straps and / or
...without the headache. Have you made sure that all the shipping bolts and stuff were removed? this happened with our Bosch and we found out we had kept three bolts installed that needed to be ...
Question about Whirlpool duet Washing Machines
...shipping bolts, spacers and the power cord are removed. 2. Unplug washer or disconnect power. 3. Check drive motor tachometer resistance. It should be approx. 115 ohms. 4. Check wire harness ...
...happens when the machine is used with the transit bolts in place is it vibrates alot, and possible moves about. Remove the bolts as soon as possible and it should be fine. I put on a load and the ...
Question about Whirlpool duet Washing Machines
...shipping bolts, spacers and the power cord are removed. 2. Unplug washer or disconnect power. 3. Check drive motor tachometer resistance. It should be approx. 115 ohms. 4. Check wire harness ...
250 questions posted
Usually answered in minutes!
9,125 Questions
187 Questions
64 Questions
34 Questions