Question about Carrier Heating & Cooling
wont our unit is realy a coleman unit but You did not have that listed. In any case it started back up again and I was so releaved as it was at least 103 degrees yeasterday. But i haove a feeling this
Question about Heating & Cooling
unit wont blow air, what could it be and what should i do to fix this? was working good but now it wont blow any air out 1st turn on your t sat to fan and see if it works if it dose then pull out your
...Unit will turn on but doesn't feel like it is blowing cold air. Have the fan on cool and temp all the way down at 60 and just blowing warm air. Wondering where i might start. Can't tell if compressor ...
Question about Dometic Heating & Cooling
...If hot wires going to that unit lose insulation and get grounded, then the moment you turn on the Ac you will have a short and the fuse will blow. Or maybe the clutch has developed an internal
Question about Heating & Cooling
...What is wrong? Why wont my unit blow cold air anymore? Possible that the compressor is not running. Call a service tech. Could be a run capacitor bad, stuck reverse valve or even a shot
unit to protect the compressor so it wont turn on and get damaged beyond repair. You can take it to your local appliance repair shop and have it looked at. I would get a quote on repair first. Most of
Question about Intertherm Heating & Cooling
WONT COOL OUTSIDE UNIT DOES NOT COME ON FAN BLOWS INSIDE INTERTHERM MODEL FEHA-01-12HA-01 if the fan outside is turning on and inside fan is blowing too, then you have a compressor problem. could be a
the fan runs on the air conditioner but the the fan runs on the air conditioner window unit but the compressor wont turn on. Therefore, no cold air is blowing. Try replacing the compressor capacitor.
...wont start Every air conditioner is equipped with at least two motors, the compressor and the fan motor. It is possible for the fan motor to be defective and the compressor to be running. If this is ...
Unit will not turn on and display cannot be reset. by simply turning power off to furnace or air handler may not work but there might be a reset button in the t-stat. remove the faceplate off of the t
14 questions posted
Usually answered in minutes!
90 Questions
61 Questions
42 Questions
37 Questions
47 Questions