Frigidaire Side by Side 26.0 Cubic Foot Total Capacity Refrigerator "remove relay switch refrigerator" Questions

noise by compressor every few min. coils were needing good cleaning,I did that. Step 1:Remove back cover. Step 2:Remove the wire hold the relay in place. Step 3:Remove wires from old relay and replace

relay switch. The compressor seemed a little hot, can that be from the relay switch? I removed the part and little black particles are falling out. Can it be the relay? I had the refigerator for about

...remove the relay from the compressor. A lot of these relays are failing lately. If the relay sounds like a slt shaker inside it is toat. if it makes no sound at all it is bad. You should beable to ...

...Remove the compressor relay by pulling it straight off from the compressor, gently. Pull the wire off of the side terminal of the relay. It is connected with a slip on connector. Firmly pull the ...

...If the compressor is not coming on check the relay switch on the side of the compressor.To check you have to remove the switch and shake it. If it rattles it needs to be

...Remove the relay and give it a shake. if it sounds like a salt shaker it is bad. If little particles come out of it, it is bad. If it makes no sound at all it is bad. The start run switch inside ...

...relay. Remove wire from Thermal overload terminal and transfer the thermal overload to the new PTC relay. Slide NEW PTC relay onto compressor terminals Transfer remaining wires from OLD PTC to the ...

...relay is ok there is a compressor problem or low freon it it don't start Check to see if the condenser fan at the back underneath near the compressor is running. If no check fan. Are the condenser ...

...the compressor there is a relay switch. To check if the switch is bad. Unplug the fridge remove the switch and shake it if it rattles it needs to be replaced.Hope this helps if not repost your ? ...

...the compressor not difficult remove cover over compressor electics relay and overload just pull off - you may have to undo cable clamps as well. rewire onto new units and push back onto compressor ...