Vtech Cordless 6041 Phone "house base power fix" Questions

...house must be sure handset ringer volume is NOT set TO off2) THE Telephone line cord and power adapter are plugged in properly.3)the handset may be too far from the telephone base. Move it close to ...

...base & handset don't ring and the answering machine doesn't pick up. i cannot fix the number of times for the ringer on my vetch phoneset I just fixed my phone. I was using a MagicJack (VoIP) and the ...

...house. The line rings busy when you call in. The phones closest to the base also are not wanting to dial out, they also give you the busy signal when you pick them up or have no dial tone also. I ...

...base. 2) While pressing down flash/find hs, reconnect the AC adapter. 3) On the handset, press and hold # until you hear a beep. Well the top selection did not work for me and Uniden is not answering ...

...house by removing a connector from the service jack then you would plug in a standard phone to that jack .. that makes sure the problem is either inside or outside .. if your phone happens to be ...

...house this is part of the outside wiring and gets fixed by the phone company. My sister has the filter as part of the inside wiring and has to fix it herself.) If only your CS5121 has a problem, try ...

...house and drilled a little hole in my base board and ran wires to each room. Also yo can use cordless phones and all you need is the main unit hooked to a power and phone line. I have three cordless ...

...base unit in the bedroom, but at the other end of the house, about 50 feet away. The same problem occurs when using this phone, until you walk to about 25 feet from the base unit and then the problem ...

...base, the hum stops. Any ideas as how to fix this? It started about a month ago. Nothing else in the house has changed. If all of your handsets have static then its likely your phone line has a ...

...base for the cordless phone system has power. If you have power then the problem may be with your telephone wiring in the house or outside. My standard checks start with checking if the jack is ...