Western Digital Caviar SE WD800JD SATA Hard Drive "set slave" Questions

set to slave. otherwise they are conflicting for the Active partion and bootloader. Regards Richard. The Seagate with Windows XP must be as master. Set WD as slave. If you want it ooposite way around,

need jumper settings for slave drive WD1600JS The BIOS is AMI. Under ADVANCED SETUP: The options listed for 1st,2nd ,3rd Boot device include: IDE-0 means Pri master ? IDE-1 means Pri slave ? IDE-2 ...

...and Slave. You want to set it up as a Slave. Sometime the connection ribbon from *********** board will have master/slave written on them. These also need to be correct depending on the

...set the jumpers on the HD to slave ? thanks you can find the jumper settings printed on the top of western digital caviar hard drives slave setting with the hard drive end jumpers facing you is 2nd ...

...Set the slave drive to boot following the primary drive. Read the bottom line and use the relevant key to save the settings. Restart the PC. Hope it helps. ...

...set this up as a slave drive in my Dell Inspiron. What are the jumper settings to do this this is a SATA HDD, so to make it a Slave drive, it will need to be on the SATA-1 or later controller (The ...

...slave set up you can find the jumper location next to the power on a hard drive and the settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 ...

Do you have the jumper setting for hard driveWD800 Do you have the jumper setting for hard drive WD800 I do what seeting you looking for? slave master here is thier web page for the information. http:

...and the secondary set to slave, if you're running both of these drives off of the same ribbon cable. You may have to go into your BIOS settings and check to make sure the Primary HD is the WD

...Slave designation is determined by jumpers on IDE drives. Most drives have adequate markings on them to identify these jumper positions. If not marked clearly, you will need the manufacturer's ...