...volt to 230 volt and need wiring diagram to make change Is the motor designed for dual voltages? The manual does not have a wiring diagram. I assume the motor lable diagram is faded or missing. Dual ...
...230 volt wiring diagram for a baldor non reversible motor http://www.baldor.com/support/literature_load.asp?ManNumber=MN1240 You didn't give a model,here's a manual on their motors and the wiring ...
I have a Powermatic model 66 table saw that hums (at the starter switch not motor ) when I turn it on. I just rewired after moving but have checked all connectors with multimeter and I think it is ...
I inherited an older Delta 10 inch table saw. While cutting lumber the blade slows down and stops. The wood is not binding the blade. With power off the blades and motor turn freely. Does the motor ...
Question about Powermatic Saws
...230 volt single phase starter on it. It would hum at startup but worked for a while then quit starting the saw. I thought the internal switch might be the problem so pulled motor and had it replaced ...
Question about Saws
...on the side of the motor. The wires are two hots (red and black), one neutral (white) and one ground (green or bare). The red and black need to come from the two terminals on a 220/230 volt
Question about Leeson Saws
than my old 1hp craftsman motor. What could the problem be? If the motor is a 115/230 volt motor and is running on 115 volts but the wiring is configured for 230 volt operation, the motor will be weak
1 questions posted
Usually answered in minutes!
386 Questions
103 Questions
81 Questions
63 Questions