RADIO WORKS FOR FEW MIN THEN STOPS TURN OFF FOR 10 MIN WILL WORK AGAIN SOUNDS LIKE A COLD SOLDER JOINT OR A BAD COMPONNET WHEN IT WARMS UP THATS WHEN IT STARTS ..TAKE OFF THE COVER SO THAT YOU CAN SEE
Question about Ranger Radio Communications
...radio....turn off for a20mins or so and turn back on to normal operation SOUNDS LIKE A COLD SOLDER JOINT OR A BAD COMPONNET WHEN IT WARMS UP THATS WHEN IT STARTS ..TAKE OFF THE COVER SO THAT YOU CAN ...
...work good Unplug it,Take the cover off,and check for cold solder joints,bad solder joints. Look it over real good,might get a magnafying glass to see the joints good.Resolder them..hope this ...
radio, antenna connected, mic gain down, key mic then lightly press down on the crystals there are 3 marked as X1 X2 and X4. Watch for devation on frequency counter. It is unlikely that you have a bad
...or fix?? It could be that a wire came loose inside switch. Solder all wires in place around switch or reheat them. Cold solder joints sometimes cause this. Solder pencil types are sold at Radio
...Cold / Broken solder joint, or flaky ribbon cable or connector. Re-seat all connectors in the radio, and while you're in there, look for any obvious solder anomalies. "Putting mo' axe in your co-ax ...
...cold solder Joint on the Board of your radio. You will need a power supply, a watt meter, dummy load and a 30 to 40 watt soldering gun, solder and solder wick. Chem wick makes the best solder wick. ...
...radio recieves another broadcast or if the squelch is turned up. The unit is only 5-6 months old. I know nothing about cb's, so I don't even know where to start troubleshooting. Any suggestions??? ...
...RADIO AND WHEN IT WARMS UP AND SHUTS DOWN TAKE A LITTLE PIECE OF WOOD OR PLASTIC AND PROBE ALL THE SOLDER CONNECTIONS TO CHECK FOR A COLD SOLDER JOINT IT MAY BE GRAY IN COLOR MAY NOT.. SEE IF IT GOES ...
Question about Connex Radio Communications
...cold solder joint if the radio has set unused for a period it could be a electrolytic capacitor. After this condition reappears preferably on the bench remove the solder side cover an gently press on ...
46 questions posted
Usually answered in minutes!
32 Questions
10 Questions
9 Questions
6 Questions