...good contact in the mic *and* the plug at the other end of the cable. Check the grounding and SWR or "match"of the antenna system, too. A poor SWR (greater than 1.5:1 or 2.0:1) can cause the ...
...6. Key Mic again and note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 ...
Question about Cobra Radio Communications
...6. Key Mic again and note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 ...
...up when you push the button all is good again.Good luck......Dan This is the wiring for a stock mic ... if it is a different one let me know Mic Wiring Stock 1- Shield 2- Audio 3- Transmit 4- ...
Question about Midland Radio Communications
...good cobera 2000 gtl try to keep the mic away from the radio speaker.check to see if its turned up to high.check your mic gain to make sure its like 1/2 open.If these fail then you could solder two ...
Question about Radio Communications
...this number down. Now key the mic down on channel 1 and write this number down. Loosen the antenna and bring it up 1/4 inch and repeat the prosess until you get lower the 1.5 and you should be
...is 1/shield 2/white 3/black 4/red.For an Astatic 4 wire it's as follows 1/shield 2/white 3/red 4/black ; for a 6 wire it is 1/shield&blue 2/white 3/red 4/black - yellow no connection . Good ...
Question about Cobra Radio Communications
good. usally on most radios you will unplug the wire that comes from the number two mic plug. you will hook you sheid witch is the 2 little black wires from the echo board to number one mic plug. then
or bad antenna(that would cause it not to show on power meter)Order replacement mic at www.copperelectronics.com Check SWR with a good SWR meter it should be 1.5:1 ratio or less on antenna/power match
Question about Cobra Radio Communications
...to a licensed tech to inspect as the fix will be from inside the radio. Also make sure your SWR is 1-1:5 and no higher than 2. You can loose distance from a high SWR and burn up your radio. Good
46 questions posted
Usually answered in minutes!
32 Questions
10 Questions
9 Questions
6 Questions