Question about Kenwood Car Audio & Video
...i turn my car on nothing happens other than the blinking red light. check the ground. it is most likely disconnecting also check the fuse between your battery and the amp and the actual amp
...amp and hooked it back up. Then i went to turn the radio on to test everything out, the head unit turned on for about two seconds then it turned off with the red power light coming on. I pressed the ...
amp; Voice) 9.No Connection 10.No Connection 11.No Connection 12.No Connection 13.No Connection 14.No Connection 15.Orange (O) Auxiliary Right Input (ARI) 16.Brown (BR ) Auxiliary Shield Ground (ASGN)
Red - Ignition Black - Ground Light Green - E-brake Purples, greens, whites, and grays - speakers Purple\white - reverse signal Blue\white or Blue - amp turn on\ power antenna Yellow\black - mute wire
Red is 12v switched accessory Black is ground White is front left positive White/Black is front left negative Gray is right front + Gray/Black is Right front - Green is Rear left + Green/black is Rear
red power when i manually shut it off the screen doesnt even go in and it wont play, eject the cd or anything it beeps like it's supposed to but thats it the radio wont play either.. Any help would be
red acc 12 volt batt/memory yellow yellow batt ground black black gnd power antenna blue blue ant. cont amp turn on blue/white blue/white ex. p. control. amp ground black/ white brown mute ilumination
...red, 10 amp mini ATC fuse. If this fuse is ok then continue on. In order for a radio to turn on and work you need to have 3 wires connected properly. With just these 3 the unit will turn on and act ...
...& the red lead to the PRK SW wire. Kenwood should only work when at 0 volts (brake set). Release the brake - meter shows 12 volts & the Kenwood shuts off. I hope this helps & Good
157 questions posted
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions