Audio Technica AT-PL50 Turntable "stop spinning" Questions

...stop manually spinning and press play, the record stops spinning.  Please help! take the turntable arm by your hand and place it above the record,then use the up and down lever to lower arm on ...

...stop spinning It's a Technics Sl-B2 and won't stop spinning even though the tonearm is in its holding position. I have to unplug it for the platter to stop spinning, please help It can be only one of ...

HELP: Stopped spinning When i bought the turn table it worked fine, i'd change the setting to "phono" to make the turn table spin so i could play my record and it would spin fine. But recently it just

...if the record was spinning too fast. The start and stop buttons stopped working and now the table will not spin. Any suggestions? Is there a motor that needs to be replaced? probably the belt, see ...

Hi,My platter on my Stanton T.120 will no longer spin when I hit the play/stop button.All of the lights come on,I can spin the platter with my hand manually no problem. I noticed that the spindle ...

...so i opened up the TT and adjusted the braking pot (VR201) to the right, but when i push the start/stop switch the TT would not stop, it would slow down but not completely stop, what else could i do ...

...stop spinning. if i tap the turntable it sometimes starts again for a bit but always stops. is there an internal part that has malfunctioned? There is a small motor under the turntable that either ...

...Spinning... The record player won't spin anymore. However, everything else works fine, the cd player, the radio. If you spin the record the needle still plays the music. This is puzzling because it ...

...1200 fault where both the 33 & 45 buttons remain lit, the platter spins at super speed,start stop button doesn't work and the red light is not on technics 1200 fault where both the 33 & 45 ...

...spinning backwards and very fast! and the stop start buttons also dont work on this deck.. any suggestions? these motors are quite cheap. You can open it up yourself and see if any resistors are ...