Question about Dremel Tools & Hardware - Others
switch does not work correctly nothing until its nearly full up then its going to slow You have an open spot in the switch. You will need to replace the variable speed switch. The part number is ...
...What do you suggest I can check- this is an expensive guess on part replacement. replace the hat switch. hat = High Air temp. This switch is located on the end of the air end and usually has ...
...turn on. I looked at the brushes and they are fine. Something similiar with a belt sander on / off switch that had dirt inbetween the contacts in the switch. After cleaning the switch contacts it ...
I was in the middle of a project and it just cut out! I have a filling it's the switch, can I buy a replacement switch for it,and where? A new switch is available from Sears Service centers or ...
The pressure switch is sticking on my well pump and i want to Know How i can fix the problem? pull off the switch and see if the pipe nipple it is screwed on to is stopped up, if it is unstop or ...
Hi, my cordless dremel 10.8v does not switch on beyond switch no. 2. Please help. Thanks. The switch is defective or the brushes.But replace both.Try at eReplacementParts.com : Power Tool Parts and ...
Question about Dremel Tools & Hardware - Others
The variable speed switch on my dremel 395, can I get rep. parts The contacts are all burnt. I can't get it to run on the high rpm side. The part number you need is 2610945681 variable speed switch. I
Question about Dremel Tools & Hardware - Others
Plug it in - turn on switch - nothing happens OK there's not much to these first check, the power plug, check cable, if you can, open it up and see if there is power to the On/Off switch, if there is ...
Question about Ingersoll Rand Tools & Hardware - Others
Compressor short cycles during operation. (load / unload). hose to guage and pressure switch ok. what could be the problem? The pressure switch has an adjustment for the low pressure cut in and the ...
Question about Dremel Tools & Hardware - Others
The variable speed switch on my demel is burnt out, will a layer of solder on top of it fix it? I wouldn't recommend using solder in an attempt to recoat the electrical traces of the variable speed ...
197 questions posted
Usually answered in minutes!
35 Questions
27 Questions
32 Questions
23 Questions