Question about Sears LiftMaster Building Materials
...LED is flashing remove the bulbs and see if it stops. While you have the light bulbs out unplug the opener and use a small screwdriver to pull out on the center contacts of the light socket. Can't ...
Question about Sears LiftMaster Building Materials
My liftmaster pro started to open and then stoped. Learn LED is flashing 5 times. Pushing openerer, I hear a click but no motor noise. Also, pressing the light button does not turn it on. When I pull ...
opener stopped working, I hit the reset button and it started working again, the wired remote on the wall works, but my 2 wireless remotes do not work, I have followed directions to reprogram them but
Question about Sears LiftMaster Building Materials
liftmaster opener led flash 5 times, replaced rpm sensor ,still not working what else could it be? 5 flashes of the LED is the code for "RPM sensor or motor overload."
Question about Sears LiftMaster Building Materials
...LED flashes 5 times My Chamerlain 1/2hp opener won't open or close, and the motor hums for a few seconds when I try to activate it. It actually sounds as if the motor tries to move in one direction ...
...opener with battery backup this may help. BBU stands for 'battery back up.' This is battery related. On top of your unit is a battery pack with three colored led lights. You can tell what is ...
Question about Sears LiftMaster Building Materials
...LED over the learn button stops flashing immediately and the all is OK the opener. I could open and close it as many times (with the door disengaged). It's been installed as is for the past 4 years ...
...opener. This will re-establish the code and reset the remote. This is battery related. On top of your unit is a battery pack with three colored led lights. You can tell what is going on by looking at ...
opener beeps This is battery related. On top of your unit is a battery pack with three colored led lights. You can tell what is going on by looking at these. This information is in your manual or here
Question about Sears LiftMaster Building Materials
...ENTER KEY. IF THE LED NEXT TO THE PROGRAM BUTTON FLASHES RAPIDLY THE KEYPAD IS SENDING A CODE. TRY REPROGRAMING THE KEYPAD. IF THE LED DOES NOT FLASH, NO RADIO SIGNAL IS BEING SENT THE KEYPAD IS
5,971 questions posted
Usually answered in minutes!
0 Questions