...instructions recommended that I remove the plug on the top of the pump and replace it with a vented plug that was provided. However, none of the other enclosed manuls talk about the vented
vent plug. I have done this but when i run the washer oil spits out of the vent plug. The washer now needs more oil. Should i put the travel plug back in? Please advise? You just bought it which means
Question about Garden
I have a Workzone 2.2kW Pressure Washer and it says remove the transport oil stopper can someone tell me were this is That would be a vent cap that is plugged.
...vent to allow air in as gas flows out to the carb. most vents are built into the gas cap by little hole(s) on it. see if the hole is blocked on the bottom side of the cap with ****. if unsure, start ...
Hi I have briggs and stratton quantum xm 50 engine on a garden tiller and the engine starts fine, but after a minute or two stops and turns of by itself, than again starts without problem but again ...
...thread area (throat) 3. Drain Oil. AFTER step 5. 4. Pressure Pump oil should be fine as it is not vented. (depending on pump installed but none of them are vented. 5. Remove spark plug and put
... What would cause this oil leak? Most likely your air filter is plugged or dirty, or the crank case vent valve needs to be cleaned.if it still does it check that the oil level is at the full mark, if ...
...make sure that you don,t have the transit plug in or the pump cannot breath. It should have a air vented
make sure there are no hairline fractures in it. If in doubt then replace your plug. Also check gas tank cap to make sure that the vent holes is open.I hope some of this helps you. Thank you very much
Question about Garden
vent plug is on a pump and what it looks like The vent plug is always on the top of the pump, generally it is also the fill plug with a small vent hole in it. The head may be a hex (like a a six sided
805 questions posted
Usually answered in minutes!
273 Questions
123 Questions
72 Questions
36 Questions
34 Questions