Karcher 2500 PSI Pressure Washer "test switch" Questions

...switch.you will need to take it out of its casing and locate the plastic housing that has two wires inside. inspect this for functionality repair or replace and test unit before re-assembling CAUTION ...

...is defective however good enough to run engine. Kill with choke or pull wire. If no spark with test, make new wire from tab of coil to kill switch or any switch that will short tab to ground. Good ...

engine off while running shutting down engine while its run check oil level or oil pressure switch ( disconnect switch while testing for function )

...fuse and it is ok. Checked supply out of the on off switch also ok. if not tripping the safety fuse could be a pump problem or faulty line pressure switch would test motor separated from the ...

...switch several times. Of course I turned on the reset and test buttons several times. Still nothing. The motor does not turn on. Can I get a replacement? Joe W was you using the machine on a electic ...

...switch is a plastic assembly on the pressure head. open it up ,lubricate or file it to increase space. then test before re-assembling it, beware of possible exposed wires and chance of comming into ...

...test including the kill switch wire (always use a new spark plug for test, then place the new plug in stroage for later use). I test the coil off the engine on a growler. If the oil alert ...

...electric pressure washer stopped working while in use. We have power - red light on gfci and we tested the master switch - has power too. So what can be the problem? One post mentioned a jammed ...

...test the flow switch. The process is the same if you have a snap switch however instead of testing the terminals you will test each wire going into the switch for voltage. Next you will test the flow ...

...switch and test for continuity through the switch with a DVOM (Digital Volt Ohm Meter). If you are not sure of how to do this, you will have to take it to a repair depot. These units are not consumer ...