Karcher 2500 PSI Pressure Washer "swash plate oil" Questions

...swash plate and pistons are bathed in oil. (oil type ... I am not sure what the prior post about "The swash plate and pistons" is about. I run a technical support department for one of the leading ...

swash plate housing. You can use a multi grade motor oil such as 20w50 or 10w40. Fill to about half way over the swash plate. If the old oil has gone amilky colour, please replace the oil seals first.

...swash plate that is held down by a bolt. The swah plate could also be fitted by force fitting. After the swash plate there is an oil seal then a bearing. So if for a reason you must remove the pump ...

...swash plate there seem to be no parts available can these parts be sourced. If the manufatgurer doesnt have them, you may be out of luck. If you ran it without oil ... you are pretty much stuck. On ...

...swash plate or bearing (the pieces sitting in the oil). Fill the oil end with aproximatly 4.5 ounces of Karcher pump oil, (or just 20w 50 weight non-detergent oil). Put the brass head back on and ...

...swash plate. This oil is usually normal multi- grade engine oil. In bigger machines, grade 90 oil is used. If you are not sure, get some multi-grade and 90 oil, and test with your hand. It should be ...

...swash plate. This oil is usually normal multi- grade engine oil. In bigger machines, grade 90 oil is used. If you are not sure, get some multi-grade and 90 oil, and test with your hand. It should be ...

...swash" plate that opens 3 stainless steel thin flat valves. the bearing that the pump shaft goes through is a phospher-bronze plain bush with a seal each side and if this has dried out then you are ...

...swash plate that drives the pistons could have got loose. So the motor turns and the pump stays dead. So a good examination and service must be done to the pump. To renew all the parts I have ...