OKI B6300 Laser Printer "already replaced drum unit keeps" Questions

...already check all the posible toner/drum sensor and clean, some boards also is new, the problem is still there.. hope you can help me with this big problem of mine. thanks! and more power. Hello, ...

already purchased a new drum and TD cartridge. Older Sharp AL copiers will go on working with the drum light blinking, but yours will not. Newer models do stop working when the drum reaches its limit.

...i can't actually see defect, i would say since you replaced drum already, toner would be easiest thing to do first. keep in mind also, generic toners have a fairly high failure ...

drum? i've already changed the toner, but can't figure out how to remove old drum to replace new one. your drum cartridge should have a little rod that you can carefully pull out and in. This cleans a

...already replaced the drum,developer and cleaning blade,cleaned also the optics but no luck. I has dirty copy on the lower portion, about 1/4 inch when copying vertically but not solid dirt. if i copy ...

...already been installed. I proceeded to install the parts included in Box B hoping to clear the message. The parts are now installed as per the instructions but the "Replace Maintenance Kit" message ...

...And do it safely! I had this happen to me and turned out the imaging unit (drum ) was bad so i would recomend a new drum . OPC drum or imaging drum is already worn out or life ends. Replace new

...already removed all the **** that shipped the drum, all orange stuff is gone, the drum is in place, and you are good to go! Close the cover that exposed the drums, turn the handle clockwise to latch ...

...already. The manual is only as good as those who write it. GM blew up a lot of deisel (gasoline blocks in the early 80's) engines replacing the injector pumps. but that came down to a small part that ...