Magellan RoadMate 2000 GPS Receiver "back" Questions

...Use fingernail or tweezers to lift up the plastic locking mechanism that attaches your LCD to the backside of your mainboard. 7. Pull out LCD cable, inspect for "gunk" on conacts (clean if

Lost power- will not come back on I was using my Roadmate 700 when the power went off. This has happened before when the power cord pulled out-but simply replacing the cord end back into the ...

the power won't come back on I have a magellan roadmate model 1430 and the power won't come back on. Plugged into the socket in the car it still won't turn on. I tried to look for troubleshooting in ...

...battery thinking might be bad--removed battery and ordered one now i cant remember where to plug it back into and cant see the plug in --any ideas where it is I reached a destination using the ...

...suggestions? Thanks, [email protected] I recently i had the same issue. Open the four screws from back. remove the back cover carefully (tahe care of the attached cables). check the atena wire ...

road mate 700 I cant get the roadmate 700 to turn on at all there is no flash card in the back or what ever goes into the slot in the back is missing, is that needed? also even when i plug in the usb ...

...signal found a causation. Need help Hi. From great help of guys previous posted answer, I opened up back of Magellan 700 and found disconneted grey color wire from back side board.(There are two ...

Magellan 760 Unit stopped turning on, but hit a bump and it would turn back on. Got worse, to where it would not turn back on. Took the unit apart, and just seperating the case, got the unit to turn ...

...top. Hold down the repeat button or the one beside the slide switch and then put the slide switch back to the on position. Then select hdd tools then format. exit out and turn the switch off and ...

...reset switch on the top of your 800 to the opposite position and once it turns off, slide the reset back to the normal position and turn it on again and take it back outside and let it in clear view ...