JBL Venue SUB10 Subwoofer "stage power sound speakers" Questions

...power supply? Hi, This is usually the Capacitor C8 on the powerboard it usually bulges and pops, its becuase its right next to a resistor which gets very hot and sometimes puts the capacitor into ...

...stage feedback loop. this is something to be done by a repair technician Hi Tom, I have the exact same problem with one of my M1active 620 speakers. Awful high pitched sound when the power cable is ...

...power supply is now dead. If ther output stage is shorted and was putting DC on to the speaker cone, this will burn it very easily. You should sent the unit out and have it serviced, unless you are ...

stage though in theory the speakers should be able to handle the amp at full volume if memory serves. Is there a fix? What can I do to diagnose the problem? First, swap the speakers to see if it stays

...get a nice monster subwoofer cable and a Subwoofer PowerCenter? SW 200 with Clean Power? Stage 1 get it from like amazon and you'll definately see a difference and also put the sub in like a ...

...power supply section, output amplifier stage, pre-amp stage. Leaky capacitor will produce an out of regulation in the supply. If you have knowledge in electronics and have tools and test instruments ...

...power is plugged back in the fuse immediately blows. ok, temporary cheap fix... (i mean in a ******* engineering kinda way ;-)  . . . )since your primary receiver has a sub-out RCA plug, you can ...

...power supply circuit problem. It would be either with the large capacitors in the first stage of the supply(most likely) or with the regulation system that supplies +-15 volts to the preamp section. ...

...power stage, but I'm not 100% sure. Does anybody has an idea on where to check? Thanks, Douglas have you checked your music source? Some systems like computers have a sort of output first before ...

...Power supply or the amp outputs. If it doesnt blow, stays on but no sound, problem also likely to be output stage. You will need someone with experience to check outputs, etc and a meter though. Hope ...