HP DesignJet 430 rejecting media Hey, I have an HP DesignJet 430 plotter. After it ran out of paper I changed the roll and now it loads the media, goes thru all the motions and cuts the paper, then ...
paper load incorecctly i used this ploter without any problem but today i wanted to put another paper roll but i get this error message paper load incorecctly everythhing is allright and the same as ...
loading paper. If the paper cannot be loaded without skew then either you do not have the roll seated on the holder properly or the roll of paper was not made properly, which I have seen. You may call
error 45.1.03 for t770 switch off the machine, remove paper and spindle of both roll & 2, close the roll covers, switch on the machine wait until ready mode appears, select load media, select roll
Question about HP DesignJet Office Equipment & Supplies
...loading the paper, the edge sensors can be a bit tricky. Pull the paper through the main guide with the locking plate released. Guide the paper edge it's right along the blue (not over it, just along ...
Question about HP DesignJet Office Equipment & Supplies
loading roll paper printhead path type 1 Going through the initial setup after turning on the plotter, the screen states "Paper Loaded Incorrectly, Remove Paper". After the paper is removed ...
Question about HP DesignJet Office Equipment & Supplies
Plotter wont recognize edge of clear films when loaded from a roll or sheet. recognized plain paper fine I would check the sensor on the carriage that detects paper. It might be dirty enough that ...
Question about HP DesignJet Office Equipment & Supplies
Paper missaligned please unload and restart' the best solution is two fold 1. have a service technician perform a platen blue line media calibration on your machine ( this corrects the blue line Shift
Question about HP DesignJet Office Equipment & Supplies
clear film won't load and plotter says "can't find edge of paper" I have just loaded a 35" roll of transparent film, that I want to print black onto. Everything seems fine, the printer starts to load ...
...out and re-loading it, but I still get out of paper message. remove any paper off/on machine re-insert paper check and select the right type of paper,if still same problem call for a service ...
93 questions posted
Usually answered in minutes!
125 Questions
147 Questions
140 Questions
140 Questions
87 Questions