tray. Now it says "no paper pick-up, even though I have 2 trays I can get neither to work. I have tried nv ram. The printer is only 3 months old and I can see nothing wrong with the rollers Check
...tray from the printer 2. Remove the top clear plastic lid from the paper tray 3. Insert the paper tray into the printer making sure the silver level is below the plastic plate (the piece that has the ...
Question about HP OfficeJet Office Equipment & Supplies
...tray slot (the left slot) on the right wall roughly 1 1/2 inches in you will see a tiny white square piece that you can easily reach with your index finger. Just apply light pressure to the top of ...
...tray 2 below the printer with no duplex unit at all to see if the printer sees tray 2. If it does see it then the problem is in the duplex unit. If the printer can't see the duplexer it also wont ...
...tray out at a slight angle this caused the try to catch on the paper level sensor tab and pulled it out of place. Since this was out of place when the printer lifted the paper, the printer did not ...
...2. Lift the scanner unit to expose the inside, where the printer cartridges are located. 3. Gently slide the ink cartridge carrier to the middle of the printer. 4. Gently move the top part of the ...
Question about Panasonic Office Equipment & Supplies
2" I can not receive faxes because of this issue. I have opened all of the doors and cleared all paper jams. I also filled both paper trays but the error wont clear. Can you hear the cassette tray POP
Question about HP OfficeJet Office Equipment & Supplies
...tray 2 which is 11x17. There are slight buffed marks at on the papaer in 4 spots but paper wont advance. marks are about 1/4 inch long those marks are the rollers trying to move the paper. check to ...
...tray is pushed down too far and 2 flimsy stop tangs on the backside of the tray hinge break off. The one on the left side contacts a microswitch, pushing it forward , signaling the printer tray is ...
...2. the tray itself is overloaded with paper 3. the tray is not full enough to pick up paper 4. the tray will not lift to allow the paper to be picked up 5. the rollers have become worn,dirty, or weak ...
899 questions posted
Usually answered in minutes!
2,817 Questions
1,584 Questions
1,223 Questions
991 Questions
857 Questions