Duo-therm fan only runs on low I have a duo-therm self-contained air-conditioner/heat pump basement unit that the fan will not change speeds....how do I trouble shoot this useually a sticking fan ...
Duo-Therm model #57915.531,compressor keeps running after condensor fan shuts off.Relay? circuit board? yes i would say it is a relay or it been wired incorrectly. you can check it manually by pushing
Question about Dometic Heating & Cooling
duo therm air conditioner that the compressor will not start I have a duo therm model 59516.331 that the compressor will not start. Thermostat seems to work fine for the furnace, the fan runs both low
...Duo-Therm roof top. The compressor wont shut off. When the stat is satisfied the fan stops but not the compressor. I pulled the metal control box but didnt see a real set of contacts. Where are they? ...
Question about Dometic Heating & Cooling
documentation that you need. If you do not have a Coleman and it is in fact a Duo-Therm, let me know the model number and I will be able to pull up the wiring schematic. Thanks, Jeff Rate this please!
...Duo Therm. When I select the cool position on the t-stat both the heat strip and the compressor try to kick on. This is overloading the 20amp circuit. I am still struggling to find out why this is ...
Question about Dometic Heating & Cooling
Duo Therm Quick Cool A/C fan motor cycles from low to high My neighbor in the RV park has a Duo Therm Quick Cool high performance by dometic A/C unit. She tells me that years ago she had a heating ...
Question about Dometic Heating & Cooling
duo-therm AC unit on my RV the compressor ran continuosly, had to shut it off at the breaker. I too replaced the relay board thinking it was a stuck relay but the problem was still there. Good news is
...duo therm) roof top (brisk Air) air conditioner comes on when switch is turned on and stays on no matter what the temp setting. the thermostat is a dual heat and air control. the furnace works fine ...
red wires. Control unit = Dometic Duo Therm 3107541.009 Analog Control. did you ohm the relays to verify a correct path? It sounds like the relay contacts are not "making" and providing a pth for flow
2,853 questions posted
Usually answered in minutes!
95 Questions
12 Questions