Kenmore 46462 Front Load Washer "solonoid" Questions

...Hello, Yes with the hoses supplying good water pressure and the screens on the solonoid vale being clear the FH error code is caused by the water inlet valve (solonoid

...no water at any time. Hope you can help me , Thanks, Bob washers are pretty robust. Possibly the solonoid is faulty or possibly a wire has simply pulled off the terminal. Need to remove top ...

...cycle take forever. Also, there is no end-of-cycle signal, should there be? your cold water solonoid has either got a dirty filter or the solonoid needs to be stripped and serviced if the ...

hot water only front loader model wcvh6260fww It could be an open circuit coil on the cold inlet solonoid or a faulty diaphram in the solonoid.If you havn,t got a tester try changing the coils over ...

...properly it still has washing powder on it , what could this be It could be that your cold water solonoid is at fault. Also is water pumping out ok at end of cycle? this often happens and machine ...

...eg the pump winding may be burned or the heater may be shorting to ground.It could also be an inlet solonoid (water).To check them you will need to unplug the machine and by disconnecting the pump ...

...water when trying to use it nothing no cold water when trying to use it nothing Your cold water solonoid is not working and needs to be replace. Very easy fix. Just follow the cold water supply ...

...and doesn't spin at all. Hello, That problem with your washer sounds like its the mode shifter solonoid,To check it use a multimeter set to ohms and measure for appx. 98 ohms on that solonoid ...

...of control panel issues? Could be but also could be rinse water valve not operating due to faulty solonoid. it does a final rinse / softner before spinning if valve faulty then no spin advance.... ...

water not flowing There could be a few reasons for this problem.It is probably a faulty out of balance micro switch,Located under the main motor controller board in the head section.Bypass the switch ...