HP LaserJet 3050 All-In-One Printer "copier error network interface service" Questions

...error occurs when the printer does not understand the Print Job Language. Following could be the reason: Faulty Network Cable/Port Corrupt Driver Firmware of the printer and the Jetdirect Interface. ...

...be able to print. You also need to have a N BOOT-ROM (included in network kit). There Should be a N next to the number for BOOT-ROM under Copier > Display > Version if a N BOOT-ROM is

...Error 49 by Stephen (edited 3/20/07 12:29 PM) reply + / - It could be a bad job. First disconnect it from your network and any PC it might be attached to. Power cycle it, then if it goes to ready ...

...network cables. (power can be on) Attempt to duplicate error using only built in test prints. After determining if you can get errors with the built in tests continue troubleshooting. Hopefully you ...

network or a computer. 5 Turn the MFP off. 6 Remove all DIMMs and flash-memory cards. Do not remove the firmware memory card that is in slot 1. 7 Remove all of the EIO devices. 8 Turn the MFP on. 9 If

...me the error : Network Interface is out of service. What is wrong with it? sounds like your NIC card is bad, no network cable plugged in or the network port in the wall is not an active network

error 116-324 keeps coming up. i have turned machine on and off, what do I do? 1. Power off the printer using the power switch located on the right side of the printer, toward the back. Press the ...

...error, how to solve? [Cause] During the transfer using SMB of the scan to PC feature, the SMB server could not be found. [Remedy] Take one of the following actions, and try again: Check the following ...

...error bubble on the screen it says "Set Key Counter" I would love to be able to use this machine - any ideas? There is a service code to disable the key counter. I'll have to look it up. If you are ...

...network error" thus not letting me scan. the network is fine, i can print over it with no problem and i have access to the printer's web page without an issue. Am i doing something wrong. You have to ...