Maytag MAH6500 Neptune Front Loading Washer w/Built in Water Heater "problems" Questions

...bought a neptune washer and dryer, my husband said it had good reviews but after having some problems with ours I did some research myself and found out otherwise. I have read everyone's ...

washer will not spin. What are common causes for this problem? Hi, Problems with a washing machine not spinning or not draining are often interrelated.. If you are having a problem with your top load ...

I have a maytag washer and it washes but will not rinse or spin, what could be the problem ? Hi, Problems with a washing machine not spinning or not draining are often inter related.. If you are ...

...piece of ****, will not drain water out. whats the problem with this piece of junk maytag sells Hi, Problems with a washing machine not spinning or not draining are often interrelated.. If you are ...

...replaced the pump and it still has the same symptoms. what should i do to fix this problem. Hi, Problems with a washing machine not spinning or not draining are often interrelated.. If you are ...

Rubber on inside has a three inch cut Rubber on the inside of my washer has a 3 to four inch cut. I just noticed this and don't know if this will be a problem. yes it is a problem, it will leak water ...

when the wash cycle is complete the water begins to fill up again and will not stop. it eventually overflows onto the floor Yes a water valve sounds reasonable to be the problem. After it enters the ...

MATAG NEPTUNE WAHER LEAKS FROM FRONT DOOR MY MATAG NEPTUNE LEAKS FROM THE FRONT DOOR WHEN GOING THROUGH WASH AND SPIN CYCLE. MY MODEL # IS MAH55FLBWW. CAN YOU TELL ME WHAT THE PROBLEM MAY BE?? HELP, I

spin cycle does not work Hi, Problems with a washing machine not spinning or not draining are often interrelated.. If you are having a problem with your top load washer then check out thistip... ...

washer does"nt do last spin Hi , I have problems with my washer , it doesn't do last spin. I already used one of the solving problems from on line. The tip I used was to unplug the machine and plug ...